Wavetek 3SR Specifikace stáhnout pdf (Strana 24)

4-1

SECTION 4 OPERATION - HOW TO USE THE 3SR RECEIVER

4.1 INTRODUCTION

This section provides detailed operation of the Model 3SR Receiver.

Included are detailed descriptions of the various displays of the

selected modes of operation.

4.2 STEALTH START-UP PROCEDURE

After the receiver is properly connected, the next step is to build a

channel plan. This channel plan will designate which channels are

active in the system, which channels are scrambled, and which

channels are inactive. The channel plan can be edited to indicate

which channels are to be tested in the Tilt mode, and to label the

channels with the programming content or call letters of the broad-

caster.

The following procedure describes the steps to prepare the receiver

for use.

Building A Channel Plan

1. To build a channel plan, first enter the setup mode by pressing the

SETUP key.

2. Press the Channel Plan soft key, and cursor down the menu to Build

Channel Plan.

3. Press the ENTER key, and you will be prompted at the first step to

name the channel plan to be built. The name should be a logical

one that will be easy to remember. The location of the headend is

usually a good name for the channel plan. When the name is typed

in, press the OK soft key.

4. The next step is to choose a channel plan from the built-in list that

most closely resembles the plan of your system. Typically your

system channel plan will be a subset of the built-in plan. Cursor

down to the appropriate channel plan and press the ENTER key or

the OK soft key.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 124 125

Žádné komentáře

Wavetek 3SR Specifikace Strana 24